Schneider Electric Altivar 320 · Fault SAFF: Safety function detected error
What it means A safety-function condition has been detected: debounce time or the SS1 threshold was exceeded, the configuration is incorrect, or SLS-type overspeed occurred.
✓ Checked against the manual (Oct 2026): code and name match the official manual, printed page 416.
Troubleshooting
Troubleshooting steps for this code sit behind a short safety notice. Read it before you open them.
Troubleshooting
Safety first
Before troubleshooting: shut down the equipment, isolate every energy source, lock and tag the energy-isolating devices, release or restrain stored energy, and verify by try-out that all energy is neutralized before work begins.
Follow your site’s written energy-control procedure and the manufacturer’s manual. This is general information only and does not replace a qualified person, site safety requirements, or OSHA requirements.
From the official manual, printed page 416. Official manual (PDF). Status: see the manual.
Safe first checks
Confirm the displayed code and review the drive fault history.
Inspect relevant wiring, connections, and installation conditions without defeating any safety circuit.
Consult the Schneider troubleshooting procedure for this code before reset or re-energization.
Source
Name as printed in the official Schneider Electric manual for the Altivar 320, printed page 416. Meaning and checks are reworded, not copied. Official manual (PDF). Codes and names can differ between firmware versions.