Lock out, tag out, verify zero energy. Not a replacement for the manual or a qualified tech.
ALARM 52
Danfoss VLT AutomationDrive FC 302 · Alarm ALARM 52: AMA low Inom
What it means Measured motor current is too low for AMA.
✓ Checked against the manual (Oct 2026): code and name match the official manual, printed page 89.
Troubleshooting
Troubleshooting steps for this code sit behind a short safety notice. Read it before you open them.
Troubleshooting
Safety first
Before troubleshooting: shut down the equipment, isolate every energy source, lock and tag the energy-isolating devices, release or restrain stored energy, and verify by try-out that all energy is neutralized before work begins.
Follow your site’s written energy-control procedure and the manufacturer’s manual. This is general information only and does not replace a qualified person, site safety requirements, or OSHA requirements.
Live workManual's first check Check the settings in parameter 1-24 Motor Current.
Verify motor wiring and motor rating.
Check for an open or incorrectly connected motor circuit.
Source
Name as printed in the official Danfoss manual for the VLT AutomationDrive FC 302, printed page 89. Meaning and checks are reworded, not copied. Official manual (PDF). Codes and names can differ between firmware versions.