Old Hand Fault Finder

Danfoss VLT AutomationDrive FC 302 · Alarm WARNING/ALARM 11: Motor thermistor overtemp

What it means The motor thermistor indicates overtemperature or is disconnected; warning/alarm behavior is parameter-selected.

✓ Checked against the manual (Oct 2026): code and name match the official manual, printed page 85.

Troubleshooting

Troubleshooting steps for this code sit behind a short safety notice. Read it before you open them.

Before you troubleshoot

Please read and check each statement.

Old Hand Fault Finder provides general information only. It is not legal advice, engineering advice, or a substitute for a manufacturer’s manual, a qualified person, or your site’s written procedures.

Follow OSHA lockout/tagout requirements and your site’s written energy-control procedures. Follow the manufacturer’s manual for the exact drive and equipment in front of you.

Only qualified people should perform work that requires qualification. Old Hand gives no live-work guidance. For any live work, follow the manufacturer’s directions and your site’s procedures.

Old Hand makes no warranty about the completeness, accuracy, suitability, or results of this information. Use of this site is at your own risk.

Check all 5 statements

Source

Name as printed in the official Danfoss manual for the VLT AutomationDrive FC 302, printed page 85. Meaning and checks are reworded, not copied. Official manual (PDF). Codes and names can differ between firmware versions.