Danfoss VLT AutomationDrive FC 302 · Alarm WARNING/ALARM 13: Over current
What it means Inverter peak current exceeded approximately 200% of rated current; after the warning interval the converter trips and alarms.
✓ Checked against the manual (Oct 2026): code and name match the official manual, printed page 85.
Troubleshooting
Troubleshooting steps for this code sit behind a short safety notice. Read it before you open them.
Troubleshooting
Safety first
Before troubleshooting: shut down the equipment, isolate every energy source, lock and tag the energy-isolating devices, release or restrain stored energy, and verify by try-out that all energy is neutralized before work begins.
Follow your site’s written energy-control procedure and the manufacturer’s manual. This is general information only and does not replace a qualified person, site safety requirements, or OSHA requirements.
With power isolated, check whether the motor shaft can turn.
Verify motor size and motor data parameters 1-20 to 1-25.
Check for shock loading, rapid acceleration, or wiring faults.
Source
Name as printed in the official Danfoss manual for the VLT AutomationDrive FC 302, printed page 85. Meaning and checks are reworded, not copied. Official manual (PDF). Codes and names can differ between firmware versions.