Danfoss VLT AutomationDrive FC 302 · Alarm WARNING/ALARM 34: Fieldbus communication fault
What it means The fieldbus on the communication option card is not working.
✓ Checked against the manual (Oct 2026): code and name match the official manual, printed page 87.
Troubleshooting
Troubleshooting steps for this code sit behind a short safety notice. Read it before you open them.
Troubleshooting
Safety first
Before troubleshooting: shut down the equipment, isolate every energy source, lock and tag the energy-isolating devices, release or restrain stored energy, and verify by try-out that all energy is neutralized before work begins.
Follow your site’s written energy-control procedure and the manufacturer’s manual. This is general information only and does not replace a qualified person, site safety requirements, or OSHA requirements.
Check fieldbus cabling, connectors, and termination.
Check option-card installation and network status.
Verify node/address and communication settings against the network design.
Source
Name as printed in the official Danfoss manual for the VLT AutomationDrive FC 302, printed page 87. Meaning and checks are reworded, not copied. Official manual (PDF). Codes and names can differ between firmware versions.