Allen-Bradley PowerFlex 755 · Fault 210: HW Enbl Jmpr Out
What it means A safety option is present and the enable jumper is removed.
✓ Checked against the manual (Oct 2026): code and name match the official manual, printed page 327.
Troubleshooting
Troubleshooting steps for this code sit behind a short safety notice. Read it before you open them.
Troubleshooting
Safety first
Before troubleshooting: shut down the equipment, isolate every energy source, lock and tag the energy-isolating devices, release or restrain stored energy, and verify by try-out that all energy is neutralized before work begins.
Follow your site’s written energy-control procedure and the manufacturer’s manual. This is general information only and does not replace a qualified person, site safety requirements, or OSHA requirements.
Verify the installed safety option and jumper arrangement.
Inspect the enable-jumper location under qualified procedures.
Consult the applicable safety-option manual before any change.
Source
Name as printed in the official Allen-Bradley manual for the PowerFlex 755, printed page 327. Meaning and checks are reworded, not copied. Official manual (PDF). Codes and names can differ between firmware versions.