Yaskawa V1000 · Fault oH3: Motor Overheat 1 (PTC input)
What it means The motor PTC signal at analog input A1 or A2 exceeded its configured overheat alarm level.
✓ Checked against the manual (Oct 2026): code and name match the official manual, printed page 274.
Troubleshooting
Troubleshooting steps for this code sit behind a short safety notice. Read it before you open them.
Troubleshooting
Safety first
Before troubleshooting: shut down the equipment, isolate every energy source, lock and tag the energy-isolating devices, release or restrain stored energy, and verify by try-out that all energy is neutralized before work begins.
Follow your site’s written energy-control procedure and the manufacturer’s manual. This is general information only and does not replace a qualified person, site safety requirements, or OSHA requirements.
Check load, motor shaft, brake, and mechanical obstruction with zero energy verified.
Inspect cooling path, fan, and ambient conditions.
Compare motor/drive ratings and relevant protection parameters with the manual.
Source
Name as printed in the official Yaskawa manual for the V1000, printed page 274. Meaning and checks are reworded, not copied. Official manual (PDF). Codes and names can differ between firmware versions.